Cisco ONS 15454 Series Procedure Manual page 98

NTP-A274 Install the FC_MR-4 Cards
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Warning Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100
mm could pose an eye hazard. Statement 1056
Use of controls, adjustments, or performing procedures other than those specified may result in
Warning
hazardous radiation exposure. Statement 1057
High-performance devices on this card can get hot during operation. To remove the card, hold it by
Warning
the faceplate and bottom edge. Allow the card to cool before touching any other part of it or before
placing it in an antistatic bag. Statement 201
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you installed XCVT cards, review
Step 1
installed XC10G cards, review
Open the card latches/ejectors.
Step 2
Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
Step 3
receptacle at the back of the slot.
Note
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Step 4
Note
Verify the LED activity:
Step 5
• The red FAIL LED turns on for 20 to 30 seconds. The ACT LED is amber for 3 to 5 seconds.
• The red FAIL LED blinks for up to 2 minutes.
The FAIL and ACT LEDs blink once and turn off for 1 to 5 seconds.
•
Cisco ONS 15454 Procedure Guide, R5.0
2-12
Table 2-2 on page 2-5
If you install the wrong card in a slot, complete the
procedure on page 2-17 and install the correct card.
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
Table 2-1 on page 2-3 to determine card/slot compatibility. If you
to determine card/slot compatibility.
"NTP-A116 Remove and Replace a Card"
Chapter 2 Install Cards and Fiber-Optic Cable
May 2006