Table 18-11 Line Options For The Ds3-12E And Ds3N-12E Cards - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A167 Change Line and Threshold Settings for the DS3-12E or DS3N-12E Cards
Table 18-11
Parameter
Admin
State
Service
State
AINS Soak Sets the automatic in-service soak period.
Table 18-12
Cisco ONS 15454 Procedure Guide, R5.0
18-38
Line Options for the DS3-12E and DS3N-12E Cards (continued)
Description
Sets the port service state unless network
conditions prevent the change.
Identifies the autonomously generated
state that gives the overall condition of
the port. Service states appear in the
format: Primary State-Primary State
Qualifier, Secondary State.
describes the values on the Provisioning > Line Thresholds tabs for the DS3E cards.
Chapter 18
Options
IS—Puts the port in-service. The port
service state changes to IS-NR.
IS,AINS—Puts the port in automatic
in-service. The port service state
changes to OOS-AU,AINS.
OOS,DSBLD—Removes the port from
service and disables it. The port service
state changes to OOS-MA,DSBLD.
OOS,MT—Removes the port from
service for maintenance. The port
service state changes to OOS-MA,MT.
IS-NR—(In-Service and Normal) The
port is fully operational and performing
as provisioned.
OOS-AU,AINS—(Out-Of-Service and
Autonomous, Automatic In-Service)
The port is out-of-service, but traffic is
carried. Alarm reporting is suppressed.
The ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in
OOS-AU,AINS state for the duration of
the soak period. After the soak period
ends, the port service state changes to
IS-NR.
OOS-MA,DSBLD—(Out-of-Service
and Management, Disabled) The port is
out-of-service and unable to carry
traffic.
OOS-MA,MT—(Out-of-Service and
Management, Maintenance) The port is
out-of-service for maintenance. Alarm
reporting is suppressed, but traffic is
carried and loopbacks are allowed.
Duration of valid input signal, in hh.mm
format, after which the card becomes in
service (IS) automatically
0 to 48 hours, 15-minute increments
DLPs A100 to A199
March 2007

Advertisement

Table of Contents
loading

Table of Contents