Dlp- A11 Remove The Backplane Sheet Metal Cover - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
Grasp the cover on each side.
Step 2
Gently pull the cover away from the backplane.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-A11 Remove the Backplane Sheet Metal Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To remove the backplane sheet metal cover, loosen the five screws that secure it to the ONS 15454 and
Step 1
pull it away from the shelf assembly.
Loosen the nine perimeter screws that hold the backplane sheet metal cover(s) in place.
Step 2
Lift the panel by the bottom to remove it from the shelf assembly.
Step 3
Store the panel for later use. Attach the backplane cover(s) whenever EIA(s) are not installed.
Step 4
Step 5 Return to your originating procedure (NTP).
March 2005
This task removes the backplane sheet metal cover that is installed on the
backplane when electrical interface assemblies (EIAs) are not installed.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
DLP-A10 Remove the Lower Backplane Cover, page 17-10
Required
Onsite
None
DLP-A11 Remove the Backplane Sheet Metal Cover
Cisco ONS 15454 Procedure Guide, R5.0
17-11