Dlp- A392 View Ce-Series Ether Ports And Pos Ports Utilization Pm Parameters - Cisco ONS 15454 Series Procedure Manual

DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters
Note
Return to your originating procedure (NTP).
Step 5
DLP-A392 View CE-Series Ether Ports and POS Ports Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the CE-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > Ether Ports > Utilization
Utilization tabs.
Cisco ONS 15454 Procedure Guide, R5.0
20-88
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task enables you to view CE-Series Ether Port and POS Port
utilization PM counts at selected time intervals to detect possible
performance problems.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Chapter 20
"NTP-A253 Change the PM Display" procedure
(Figure 20-19) or Performance > POS Ports >
DLPs A300 to A399
March 2005