Cisco ONS 15454 Series Procedure Manual page 172

NTP-A127 Verify Network Turn Up
Table 6-2
Card
All OC-192 cards
FC_MC-4
Table 6-3
Table 6-3
Card
DS1-14, DS1N-14
DS3-12, DS3N-12, DS3-12E, DS3N-12E
DS3XM-6
DS3XM-12
DS3i-N-12
DS3/EC1-48
EC1-12
OC3 IR 4/STM1
OC3-8
OC12 IR/STM4 SH 1310
OC12 LR/STM4 LH 1310
OC12 LR/STM4 LH 1550
OC12 IR/STM4 SH 1310-4
All OC-48 cards (includes ML-Series card)
All OC-192 cards
FC_MC-4
1. You can route one STS circuit on a DS1 card to carry all 14 ports within the STS. However, 14 VT1.5s are not utilized.
2. The number of "portless" interfaces depends on the system configuration. For XC and XCVT drop slots, a maximum
NTP-A127 Verify Network Turn Up
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 Procedure Guide, R5.0
6-4
CTC Circuit Source and Destination Options for VT Circuits (continued)
shows the shows the circuit source and destination options for STS circuits.
CTC Circuit Source and Destination Options for STS Circuits
1
of 6 portless transmultiplexing interfaces are supported. For XC and XCVT trunk slots and XC10G any slot, a
maximum of 12 portless transmultiplexing interfaces are supported.
This procedure verifies that the ONS 15454 network is ready for circuit
provisioning.
None
Chapter 5, "Turn Up Network"
Required
Onsite or remote
Provisioning or higher
Ports STSs
— 192
4 —
Ports
—
12
6
12, or 6 to 12 "portless"
12
48
12
4
8
—
4
—
—
4
Chapter 6 Create Circuits and VT Tunnels
VTs DS-1s
28 per STS —
— —
STSs
—
—
—
2
—
1 per port
1 per port
—
3 per port
3 per port
12
12 per port
48
192
—
August 2005