Cisco ONS 15454 Series Procedure Manual page 104

NTP-A20 Replace the Front Door
Physically remove the card:
Step 3
a.
b.
Insert the new card using one of the following procedures as applicable:
Step 4
•
•
•
•
•
As needed, continue with the
Step 5
page
Stop. You have completed this procedure.
NTP-A20 Replace the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Be careful not to crimp any fiber cables that are connected to the OC-N cards. Some might not have the
Note
fiber boot attached.
Insert the front door into the hinges on the shelf assembly.
Step 1
Attach one end of the ground strap terminal lug (72-3622-01) to the male stud on the inside of the door.
Step 2
Attach and tighten the #6 Kepnut (49-0600-01) using the open-end wrench
Cisco ONS 15454 Procedure Guide, R5.0
2-18
Open the card latches/ejectors.
Use the latches/ejectors to pull the card forward and away from the shelf.
NTP-A15 Install the Common Control Cards, page 2-2
NTP-A16 Install the OC-N Cards, page 2-6
NTP-A17 Install the Electrical Cards, page 2-8
NTP-A246 Install Ethernet Cards and Connectors, page 2-10
NTP-A274 Install the FC_MR-4 Cards, page 2-11
"NTP-A247 Install Fiber-Optic Cables on OC-N Cards" procedure on
2-14.
This procedure replaces the front door and door ground strap after
installing cards and fiber-optic cables.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A3 Open and Remove the Front Door, page 1-6
Required
Onsite
None
Chapter 2 Install Cards and Fiber-Optic Cable
(Figure 2-1).
May 2006