Dlp- A131 Search For Circuits - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A131 Search for Circuits
View the current statistics columns to observe changes to PM counts for the current time interval.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A131 Search for Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
Click the Circuits tab.
Step 2
If you are in node or card view, choose the scope for the search, Node or Network (All), in the Scope
Step 3
drop-down list located at the bottom right-hand side of the screen.
Click Search.
Step 4
In the Circuit Name Search dialog box, complete the following:
Step 5
Click Find Next. If a match is found, click Find Next again to find the next circuit.
Step 6
Repeat Steps
Step 7
Return to your originating procedure (NTP).
Step 8
Cisco ONS 15454 Procedure Guide, R5.0
18-14
This task searches for ONS 15454 circuits at the network, node, or card
level.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
To search the entire network, click View > Go to Network View.
To search for circuits that originate, terminate, or pass through a specific node, click View >
Go to Other Node, then choose the node you want to search and click OK.
To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to open the card in card view.
Find What—Enter the text of the circuit name you want to find.
Match whole word only—Check this check box to instruct CTC to select circuits only if the entire
word matches the text in the Find What field.
Match case—Check this check box to instruct CTC to select circuits only when the capitalization
matches the capitalization entered in the Find What field.
Direction—Choose the direction for the search. Searches are conducted up or down from the
currently selected circuit.
5
and
6
until you are finished, then click Cancel.
Chapter 18
DLPs A100 to A199
March 2007

Advertisement

Table of Contents
loading

Table of Contents