Cisco ONS 15454 Series Procedure Manual page 687

Chapter 20 DLPs A300 to A399
Table 20-2
Table 20-2
Variable
iflnOctets
ifInDiscards
iflnErrors
ifOutOctets
ifOutDiscards
fcIngressRxDistanceExtBuffers
fcEgressTxDistanceExtBuffers
fcStatsLinkRecoveries
fcStatsRxCredits
fcStatsTxCredits
fcStatsZeroTxCredits
fibreStatsInvalidOrderedSets
fibreStatsEncodingDispErrors
fibreStatsRxFramesTooLong
fibreStatsRxFramesBadCRC
fibreStatsRxFrames
fibreStatsRxOctets
fibreStatsTxFramesBadCRC
March 2005
lists the enhanced mode MIBs that are available.
FC_MR-4 Threshold Variables Fiber Channel/FICON Enhanced
Mode (MIBs)
Definition
Total number of octets received on the interface, including framing
octets.
The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent them from being
deliverable to a higher-layer protocol.
Number of inbound packets discarded because they contain errors.
Total number of transmitted octets, including framing packets.
The number of outbound packets that were chosen to be discarded
even though no errors had been detected to prevent them from being
transmitted.
The maximum number of GFP buffers that are available at the GFP
receiver.
The number of GFP buffers that the GFP transmitter is allowed to
transmit. Remote GFP receiver tells the GFP transmitter how many
buffers it has available.
The number of times a link reset was initiated due to a GFP out of
frame condition. This is only valid when link recovery is enabled
and is not valid when distance extension is enabled.
The maximum number of Fibre Channel credits that the Fibre
Channel/fiber connectivity (FICON) link partner will allow the
FCMR Fibre Channel/FICON transmitter to transmit. (The
maximum number of frames the link partner can receive.)
The number of Fibre Channel credits that the FCMR Fibre
Channel/FICON transmitter is left with. This is the number of
frames that the Fibre Channel/FICON transmitter has available to
send.
Note
This is a count that increments when the Fibre Channel/FICON Tx
credits go from a non-zero value to zero.
Received ordered sets that are not recognized as part of the defined
Fibre Channel control words.
Received control words that cannot be decoded due to invalid
disparity.
Received oversize Fibre Channel frames > 2148 including CRC.
Received Fibre Channel frames with bad CRC.
Received total Fibre Channel frames.
Received total Fibre Channel data bytes within a frame.
Transmitted Fibre Channel frames with bad CRC.
DLP-A357 Create FC_MR-4 RMON Alarm Thresholds
The Tx credits increment whenever a credit is received from
the link partner, and decrement when a frame is sent.
Cisco ONS 15454 Procedure Guide, R5.0
20-43