Cisco ONS 15454 Series Procedure Manual page 472

DLP-A52 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Automatic Host Detection
Click the IP Address tab.
f.
In the IP Address window, click Specify an IP address.
g.
In the IP Address field, enter any legitimate IP address other than the node IP address.
h.
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
i.
255.255.255.0 (24 bit).
Click OK.
j.
In the TCP/IP dialog box, click the Gateway tab.
k.
l. In the New Gateway field, type the address entered in Step h. Click Add.
m. Verify that the IP address appears in the Installed Gateways field, then click OK.
When the prompt to restart your PC appears, click Yes.
n.
If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
Step 4
configuration:
From the Windows Start menu, choose Settings > Control Panel.
a.
In the Control Panel dialog box, click the Network icon.
b.
In the Network dialog box, click the Protocols tab, choose TCP/IP Protocol, then click Properties.
c.
Click the IP Address tab.
d.
In the IP Address window, click Specify an IP address.
e.
In the IP Address field, enter any legitimate IP address other than the node IP address.
f.
g. In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
255.255.255.0 (24 bit).
h. Click Advanced.
i. In the Gateways List, click Add. The TCP/IP Gateway Address dialog box appears.
Type the IP address entered in Step
j.
Click Add.
k.
Click OK.
l.
Click Apply.
m.
Reboot your PC.
n.
If you have Windows 2000 installed on your PC, complete the following steps to change its TCP/IP
Step 5
configuration:
From the Windows Start menu, choose Settings > Network and Dial-up Connections >
a.
Local Area Connection.
In the Local Area Connection Status dialog box, click Properties.
b.
On the General tab, choose Internet Protocol (TCP/IP), then click Properties.
c.
d. Click Use the following IP address.
e. In the IP Address field, enter any legitimate IP address other than the node IP address.
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
f.
255.255.255.0 (24 bit).
Type the IP address entered in Step
g.
Click OK.
h.
Cisco ONS 15454 Procedure Guide, R5.0
17-62
f in the Gateway Address field.
e in the Gateway Address field.
Chapter 17 DLPs A1 to A99
March 2005