Dlp- A246 Provision E-Series Ethernet Card Mode - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
DLP-A246 Provision E-Series Ethernet Card Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot change the mode while the Ethernet card is carrying circuits. If you want change the card
Caution
mode, delete any circuits that it carries first. See the
procedure on page
In the network view, double-click the node containing the E-Series Ethernet card you want to provision,
Step 1
then double-click the Ethernet card.
Click the Provisioning > Card tabs.
Step 2
In the Card Mode area, choose one of the following:
Step 3
•
•
•
Click Apply.
Step 4
If you are using multicard EtherSwitch circuits, repeat Steps
Step 5
the node that will carry the multicard EtherSwitch circuits.
Repeat Steps
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-A247 Change an OC-N Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
September 2005
This task provisions an E-Series Ethernet card for multicard EtherSwitch
Group, single-card EtherSwitch, or port-mapped mode.
E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed.
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
9-4.
For multicard EtherSwitch circuit groups, choose Multicard EtherSwitch Group.
For single-card EtherSwitch circuits, choose Single-card EtherSwitch.
For port-mapped circuits, choose Port-mapped.
1 through 5 for other nodes as necessary.
This task changes an OC-N card while maintaining existing provisioning,
including data communications channels (DCCs), circuits, protection,
timing, and rings. This task is intended to be used when a slot is
preprovisioned and you want to change the optical speed of the card, or
when you have backed out of an automatic span upgrade.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite
Provisioning or higher
DLP-A246 Provision E-Series Ethernet Card Mode
"NTP-A278 Modify and Delete Overhead Circuits"
2 through 4 for all other Ethernet cards in
Cisco ONS 15454 Procedure Guide, R5.0
19-29