Ntp- A274 Install The Fc_Mr-4 Cards - Cisco ONS 15454 Series Procedure Manual

Chapter 2 Install Cards and Fiber-Optic Cable
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you are installing OC-N, TXP, or MXP cards, Cisco recommends that you install these before you
Note
install Ethernet cards.
If you installed XC or XCVT cards review
Step 1
If you installed XC10G cards, review
Complete the
Step 2
before installing the next card.
Note
Complete the
Step 3
E1000-2, E1000-2-G, G1000-4, or ML1000-2 cards.
Note
Continue with the
Step 4
Stop. You have completed this procedure.
NTP-A274 Install the FC_MR-4 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
May 2006
"DLP-A39 Install Ethernet Cards" task on page
If you install the wrong card in a slot, complete the
procedure on page 2-17.
"DLP-A469 Install GBIC or SFP Connectors" task on page 21-24
If you need to remove a GBIC or SFP, complete the
Connectors" task on page
"NTP-A247 Install Fiber-Optic Cables on OC-N Cards" procedure on page
This procedure installs the FC_MR-4 card, also known as the Fibre
Channel card.
FC_MR-4 card(s)
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
Table 2-1 on page 2-3
Table 2-2 on page 2-5
"NTP-A116 Remove and Replace a Card"
21-26.
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A274 Install the FC_MR-4 Cards
to determine card/slot compatibility.
to determine card/slot compatibility.
17-48. Allow each card to boot completely
if you are using
"DLP-A470 Remove GBIC or SFP
2-14.
2-11