Ntp- A266 Edit Network Element Defaults - Cisco ONS 15454 Series Procedure Manual

Chapter 15 Maintain the Node
Figure 15-14
Grip two of the jack screws and use them to carefully pull the UBIC-V away from the shelf.
Step 4
Note
Perform the
Step 5
Stop. You have completed this procedure.
NTP-A266 Edit Network Element Defaults
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
For a list of card and node default settings, refer to the "Network Element Defaults" appendix in the
Note
Cisco ONS 15454 Reference Manual. To change card settings individually (that is, without changing the
defaults), see
Node Settings."
Complete the
Step 1
defaults.
Click the Provisioning > Defaults Editor tabs.
Step 2
December 2004
UBIC-V EIA Jack Screw
Inner screw
Rotation indicator
Thumbscrew
Attach backplane sheet metal covers whenever EIAs are not installed.
"DLP-A190 Install a UBIC-V EIA" task on page 18-61
This procedure edits the NE defaults using the NE Defaults Editor. The
new defaults can either be applied only to the node on which they are edited
or exported to a file and imported for use on other nodes.
None
As needed
Onsite or remote
Superuser
Chapter 11, "Change Card Settings."
"DLP-A60 Log into CTC" task on page 17-66
NTP-A266 Edit Network Element Defaults
to install the new UBIC-V EIA.
To change node settings, see
at the node where you want to edit NE
Cisco ONS 15454 Procedure Guide, R5.0
Chapter 10, "Change
15-35