Changing The Ip Address - Cisco ONS 15454 Series Procedure Manual

DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD
Figure 17-29
FAN FAIL
Push the Slot button to move to the IP address or subnet mask digit you need to change. The selected
Step 4
digit flashes.
Tip
Step 5 Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 6 When the change is complete, press the Status button to return to the Node menu.
Step 7 Repeatedly press the Port button until the Save Configuration option appears
Figure 17-30
FAN FAIL
Press the Status button to choose the Save Configuration option.
Step 8
A Save and REBOOT message appears
Figure 17-31
FAN FAIL
Press the Slot button to apply the new IP address configuration or press Port to cancel the configuration.
Step 9
Saving the new configuration causes the TCC2/TCC2P cards to reboot. During the reboot, a "Saving
Changes - TCC Reset" message displays on the LCD. The LCD returns to the normal alternating display
after the TCC2/TCC2P reboot is complete.
Note
Cisco ONS 15454 Procedure Guide, R5.0
17-72

Changing the IP Address

Slot Status
CRIT MAJ
The Slot, Status, and Port button positions correspond to the command position on the LCD. For
example, in Figure 17-29, you press the Slot button to invoke the Next command and the Port
button to invoke the Done command.
Selecting the Save Configuration Option
Slot Status
CRIT MAJ
Saving and Rebooting the TCC2/TCC2P
Slot Status
CRIT MAJ
The IP address and default router must be on the same subnet. If not, you cannot apply the
configuration.
Port
172.020.214.107
<Next Done
MIN
Port
Slot-0
Status=Save Cfg.
MIN
(Figure 17-31).
Port
Save and REBOOT?
<Apply
MIN
Chapter 17 DLPs A1 to A99
Mod>
(Figure 17-30).
Revert>
March 2005