Ntp- A149 Test G-Series Circuits - Cisco ONS 15454 Series Procedure Manual

Chapter 6 Create Circuits and VT Tunnels
Figure 6-16
NTP-A149 Test G-Series Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes you completed facility loopback tests to test the
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2 Complete the
circuit ports to the OOS-MA,MT service state.
Step 3 On the shelf graphic, double-click the circuit source card.
August 2005
Two-Port Unidirectional Transponder Mode
Stop. You have completed this procedure.
This procedure tests circuits created on G-Series cards.
Ethernet test set and appropriate fibers
fibers and cables from the source and destination ONS 15454s to the fiber
distribution panel or the DSX, and one of the following procedures:
NTP-A147 Create a G-Series STS Circuit, page 6-73
NTP-A148 Create a Manual Cross-Connect for a G-Series or E-Series Card
in Port-Mapped Mode, page 6-76
As needed
Onsite
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A230 Change a Circuit Service State" task on page 19-19
NTP-A149 Test G-Series Circuits
at the node where you will create the circuit.
to change the circuit and
Cisco ONS 15454 Procedure Guide, R5.0
6-81