Cisco ONS 15454 Series Procedure Manual page 655

Chapter 20 DLPs A300 to A399
Figure 20-1
Card View
Performance
Ether Ports
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 3
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 Troubleshooting Guide.
Note
Return to your originating procedure (NTP).
Step 5
DLP-A321 View ML-Series POS Ports PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2005
Ether Ports on the ML-Series Card View Performance Window
tab
tab
Refresh
button
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task enables you to view packet-over-SONET (POS) port PM
counts at selected time intervals on an ML-Series Ethernet card and port
to detect possible performance problems.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
DLP-A321 View ML-Series POS Ports PM Parameters
Auto-refresh
menu
"NTP-A253 Change the PM Display" procedure
Cisco ONS 15454 Procedure Guide, R5.0
Baseline Help
button button
20-11