Dlp- A533 Create Ethernet Rmon Alarm Thresholds - Cisco ONS 15454 Series Procedure Manual

DLP-A533 Create Ethernet RMON Alarm Thresholds
DLP-A533 Create Ethernet RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
Step 1 Double-click the Ethernet card where you want to create the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > RMON Thresholds tabs.
Note
Click Create.
Step 3
The Create Ether Threshold dialog box appears
Figure 22-10
From the Slot drop-down list, choose the appropriate Ethernet card.
Step 4
From the Port drop-down list, choose the applicable port on the Ethernet card you selected.
Step 5
From the Variable drop-down list, choose the variable. See
Step 6
Ethernet and POS threshold variables available in this field.
Cisco ONS 15454 Procedure Guide, R5.0
22-28
This procedure sets up RMON to allow network management systems to
monitor Ethernet ports.
None
NTP-A24 Verify Card Installation, page 4-2
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
The ONS 15454 ML-Series card uses the Cisco IOS CLI for managing RMON.
For CE-Series Ethernet cards, click the Provisioning > Ether Ports > RMON Thresholds tabs
or Provisioning > POS Ports > RMON Thresholds tabs.
Creating RMON Thresholds
(Figure 22-10).
Table 22-5 and
Chapter 22 DLPs A500 to A599
Table 22-6 for a list of the
October 2005