Ntp- A47 Subtend A Blsr From A Path Protection - Cisco ONS 15454 Series Procedure Manual

Chapter 5 Turn Up Network
Log into a path protection node that connects to the node in
Step 5
4 is the only other node in the path protection.)
Complete the
Step 6
that will carry the path protection. Alternatively, if additional bandwidth is needed for CTC
management, complete
Repeat
Step 7
As needed, complete the
Step 8
As needed, complete the
Step 9
From the View menu, choose Go To Network View to view the subtending rings.
Step 10
Complete the
Step 11
Stop. You have completed this procedure.
NTP-A47 Subtend a BLSR from a Path Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the path protection node that will subtend the BLSR, install the two OC-N cards that will serve as the
BLSR trunk (span) cards (in
Install the OC-N Cards" procedure on page
Attach fibers from the cards in
Step 2
Figure 5-12 on page
Slot 5/Node 1.
Log into the ONS 15454 that will subtend the BLSR (the node in Step 1). See the
Step 3
CTC" task on page
Create the DCCs on both OC-N trunk cards (east and west) that will carry the BLSR. See the
Step 4
Provision Section DCC Terminations" task on page
needed for CTC management, complete
page
Create the subtending BLSR:
Step 5
a.
b.
Step 6 From the View menu, choose Go to the Network View to see the subtending ring.
December 2004
"DLP-A377 Provision Section DCC Terminations" task on page 20-61
the"DLP-A378 Provision Line DCC Terminations" task on page
Step 6 for each node in the path protection.
"DLP-A380 Provision a Proxy Tunnel" task on page
"DLP-A381 Provision a Firewall Tunnel" task on page
"NTP-A177 Path Protection Acceptance Test" procedure on page
This procedure subtends a BLSR from an existing path protection.
One path protection node must have OC-N cards and fibers to carry the
BLSR
NTP-A177 Path Protection Acceptance Test, page 5-22
As needed
Onsite
Provisioning and higher
Figure 5-12 on page
5-36, Slot 5/Node 3 connects to Slot 12/Node 2, and Slot 12/Node 3 connects to
17-66. If you are already logged in, continue with Step 4.
20-62.
Complete the "NTP-A40 Provision BLSR Nodes" procedure on page 5-10
be in the BLSR. If you have already provisioned the BLSR, perform this procedure for the
subtending node only.
Complete the "NTP-A126 Create a BLSR" procedure on page
node that will subtend the BLSR) in the BLSR.
5-36, Node 3, Slots 5 and 12). See the
2-6.
Step 1 to the BLSR trunk cards on another BLSR node or nodes. In
20-61. Alternatively, if additional bandwidth is
the"DLP-A378 Provision Line DCC Terminations" task on
NTP-A47 Subtend a BLSR from a Path Protection
Step 3. (In Figure 5-12 on page
for each OC-N card
20-63.
20-64.
5-22.
"DLP-A60 Log into
for each node that will
5-12. Include the node in
Cisco ONS 15454 Procedure Guide, R5.0
5-36, Node
20-62.
"NTP-A16
"DLP-A377
Step 3 (the
5-37