Dlp- A172 Change An Optical Port To Sdh - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Table 18-22
Parameter
PSC-R
PSD-R
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A172 Change an Optical Port to SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the OC-N card where you want to provision a port for SDH.
Step 1
Click the Provisioning > Line tabs.
Step 2
In the Type field for the desired port, choose SDH.
Step 3
Note
Click Apply.
Step 4
If the card is a multiport OC-N card, for example a four-port OC-3, eight-port OC-3, or four-port OC-12,
Step 5
you can repeat Steps
Return to your originating procedure (NTP).
Step 6
March 2007
OC-N Threshold Options (continued)
Description
Protection Switching Count - Ring
BLSR is not supported on the OC-3 card;
therefore, the PSC-W, PSC-S, and PSC-R
PMs do not increment.
Protection Switching Duration - Ring
BLSR is not supported on the OC-3 card;
therefore, the PSD-W, PSD-S, and PSD-R
PMs do not increment.
This task provisions a port on an OC-N card for SDH.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Before you can change the port type to SDH, ensure the following: the EnableSyncMsg and
SendDoNotUse fields are unchecked, the card is not part of a BLSR or 1+1 protection group, the
card is not part of an orderwire channel, and the card is not a SONET data communications
channel/generic communications channel (DCC/GCC) termination point.
3 and 4 for any other ports on that card.
DLP-A172 Change an Optical Port to SDH
Options
Numeric. Can be set for 15-minute or
one-day intervals for Line (Near and Far
End). Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or
one-day intervals for Line (Near and Far
End). Select the bullet and click Refresh.
Cisco ONS 15454 Procedure Guide, R5.0
18-53