Figure - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

NTP-A258 Provision External Alarms and Controls on the Alarm Interface Controller-International
Verify the backplane wiring using the following substeps. If you are using the AEP, see the
Step 1
Install the Alarm Expansion Panel" procedure on page
to Alarm, Timing, LAN, and Craft Pin Connections" procedure on page 1-15
ONS 15454 backplane pins.
For external alarms, verify that the external device relays are wired to the ENVIR ALARMS IN
a.
backplane pins.
For external controls, verify that the external device relays are wired to the ENVIR ALARMS OUT
b.
backplane pins.
Complete the
Step 2
Step
2.
In the node view, double-click the AIC-I card on the shelf graphic. The card view appears.
Step 3
Click the Provisioning > Card tabs.
Step 4
In the Alarm Contacts area, click the Add Extension radio button if you are using the AEP. Clicking this
Step 5
option will choose the External Alarm input/output type and the AEP extension type; it will give you
access to 16 external alarm contacts.
If you did not click Add Extension, in the Input/Output area, choose either External Alarm or External
Step 6
Control. (External Alarm will limit your input/output options as explained in
Control will enable both external alarms and external controls. This will convert four of the external
alarm contacts to external controls, leaving 12 available external control contacts. The extension type for
both options is AEP.
Click Apply.
Step 7
If you are provisioning external alarms, click the External Alarms tab
Step 8
provisioning external alarms, skip Steps

Figure 7-5

Step 9
For external alarms, complete the following fields:
Cisco ONS 15454 Procedure Guide, R5.0
7-12
"DLP-A60 Log into CTC" task on page
Provisioning External Alarms On The AIC-I Card
1-12. Otherwise, see the
17-66. If you are already logged in, continue with
9
through
11
and go to
Step
Chapter 7
Manage Alarms
"NTP-A119
"NTP-A8 Attach Wires
for information about the
Step
5.) Choosing External
(Figure
7-5). If you are not
12.
December 2004

Advertisement

Table of Contents
loading

Table of Contents