Cisco ONS 15454 Series Procedure Manual page 738

DLP-A395 View BFDL PM Parameters for the DS3XM-12 Card
Note
Step 3 From the Request drop-down list choose one of the following:
Enhanced ES One Day—Enhanced errored seconds performance data for one day.
•
Enhanced BES One Day—Enhanced bursty errored seconds performance data for one day.
•
Enhanced SES One Day—Enhanced severely errored seconds performance data for one day.
•
Enhanced UAS One Day—Enhanced unavailable seconds performance data for one day.
•
Enhanced CSS/LOFC One Day—Enhanced controlled slip seconds and loss of frame count
•
performance data for one day.
Note
Step 4 In the signal type drop-down lists, choose the DS-3 port and the DS-1 port within the specified DS-3.
Step 5 Click Refresh.
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 6
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the "Performance
Monitoring" chapter in the Cisco ONS 15454 Troubleshooting Guide.
To refresh, reset, or clear PM counts, see the
page
Step 7 Return to your originating procedure (NTP).
Cisco ONS 15454 Procedure Guide, R5.0
20-94
Different port and signal-type drop-down lists appear depending on the card type and the circuit
type. The appropriate types (DS1, DS3, VT path, STS path) appear based on the card. For
example, the DS3XM-12 cards list DS3, DS1, VT path, and STS path PM parameters as signal
types. This enables you to select both the DS-3 port and the DS-1 within the specified DS-3.
The Request drop-down options are availableonly in DS1 ESF and BFDL modes. The
DS3XM-12 card can send requests for enhanced performance data to the far-end network
components. Enhanced performance data is displayed on CTC if the far-end network component
replies with the requested data. The normal response message will contain the current 15- minute
and current one-day PMs from Far-end for ES, UAS, BES, SES, CSS, and LOFC. If you select, for
example, Enhanced ES One Day from the Request drop-down list box, then CTC displays 96
15-minute PMs for ES and current PMs for BES, SES, UAS, CSS, and LOFC.
8-2.
"NTP-A253 Change the PM Display" procedure on
Chapter 20 DLPs A300 to A399
March 2005