Dlp- A394 View Ds-N/Sonet Pm Parameters For The Ds3Xm-12 Card - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Note
Return to your originating procedure (NTP).
Step 5
DLP-A394 View DS-N/SONET PM Parameters for the DS3XM-12 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the DS3XM-12 electric card where you want to view PM counts. The card
Step 1
view appears.
Click the Performance > DSn/SONET PM tabs to view the DS-N/SONET Performance parameters
Step 2
(Figure
March 2005
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task enables you to view DS-N/SONET PM parameters for
near-end or far-end performance during selected time intervals on an
DS3XM-12 electrical card and port to detect possible performance
problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VT Tunnels"
As needed
Onsite or remote
Retrieve or higher
20-21).
DLP-A394 View DS-N/SONET PM Parameters for the DS3XM-12 Card
"NTP-A253 Change the PM Display" procedure
Chapter 6, "Create Circuits
and Chapter 11, "Change Card Settings."
Cisco ONS 15454 Procedure Guide, R5.0
20-91