Dlp- A258 View Ethernet History Pm Parameters - Cisco ONS 15454 Series Procedure Manual

Chapter 19 DLPs A200 to A299
DLP-A258 View Ethernet History PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
Step 1
The card view appears.
Click the Performance > History tabs
Step 2
Figure 19-6
Card View
Performance
History tab
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 3
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Prev-n columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 Troubleshooting Guide.
September 2005
This task enables you to view historical PM counts at selected time
intervals on an Ethernet card and port to detect possible performance
problems.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Ethernet History on the Card View Performance Window
tab
Interval
menu
DLP-A258 View Ethernet History PM Parameters
(Figure 19-6).
Port Refresh Help
menu button button
Cisco ONS 15454 Procedure Guide, R5.0
19-41