Figure 6-2 Setting Circuit Routing Preferences For A Ds-1 Circuit - Cisco ONS 15454 Series Procedure Manual

Chapter 6 Create Circuits and VT Tunnels
Figure 6-2
To set the circuit path protection, complete one of the following:
Step 12
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
Fully protected paths might or might not have path protection path segments (with primary and
alternate paths), and the path diversity options apply only to path protection path segments, if any
exist.
To create an unprotected circuit, uncheck Fully Protected Path and continue with
•
To route the circuit on a BLSR protection channel, if available, uncheck Fully Protected Path,
•
check Protection Channel Access, click Yes in the Warning dialog box, then continue with
Caution Circuits routed on BLSR protection channels are not protected. They are preempted during BLSR
switches.
Step 13 If you selected Fully Protected Path in
one of the following:
• Nodal Diversity Required—Ensures that the primary and alternate paths within path protection
portions of the complete circuit path are nodally diverse.
• Nodal Diversity Desired—Specifies that node diversity is preferred, but if node diversity is not
possible, CTC creates fiber-diverse paths for the path protection portion of the complete circuit path.
• Link Diversity Only—Specifies that only fiber-diverse primary and alternate paths for path
protection portions of the complete circuit path are needed. The paths might be node-diverse, but
CTC does not check for node diversity.
If you selected Fully Protected Path in
Step 14
ring interconnect (DRI), check the Dual Ring Interconnect check box.
If you selected Using Required Nodes/Spans in
Step 15
continue with
Click Next.
a.
In the Circuit Route Constraints area, click a node or span on the circuit map.
b.
August 2005
Setting Circuit Routing Preferences for a DS-1 Circuit
13. CTC creates a fully protected circuit route based on the path diversity option you choose.
Step 17.
NTP-A181 Create an Automatically Routed DS-1 Circuit
Step 12 and the circuit will be routed on a path protection, choose
Step 12 and the circuit will be routed on a path protection dual
Step 11, complete the following substeps. If not,
Cisco ONS 15454 Procedure Guide, R5.0
Step 15.
Step 15.
6-9