Cisco ONS 15454 Series Procedure Manual page 234

NTP-A144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect
•
•
•
If the information is not correct, click the Back button and repeat Steps
Step 21
information. If the information is correct, check Route Automatically.
Click Finish.
Step 22
Complete the
Step 23
carries the circuit.
Complete the
Step 24
page
Complete the
Step 25
circuit.
To create additional circuits (spokes), repeat Steps
Step 26
Stop. You have completed this procedure.
NTP-A144 Create an E-Series Single-Card EtherSwitch Manual
Cross-Connect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In this procedure, cross-connect refers to a circuit connection created within the same node between the
Note
Ethernet card and an OC-N card connected to third-party equipment. You create cross-connects at the
source and destination nodes so an Ethernet circuit can be routed from source to destination across
third-party equipment.
Step 1 Complete the
If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
If a high number of VLANs is already used by the network, complete the
Step 3
Available VLANs" task on page 17-99
create a VLAN during each circuit creation task.)
Cisco ONS 15454 Procedure Guide, R5.0
6-66
Circuit size
VLAN names
ONS nodes
"DLP-A220 Provision E-Series Ethernet Ports" task on page 19-13
"DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership" task on
19-14.
"NTP-A146 Test E-Series Circuits" procedure on page 6-72
This procedure manually creates a single-card EtherSwitch cross-connect
between E-Series Ethernet cards and OC-N cards connected to non-ONS
equipment.
E-Series Ethernet cards (E100T-12/E100T-G, E1000-2/E1000-2-G) must
be installed at the circuit source node.
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A314 Assign a Name to a Port" task on page
2 through 25.
at the node where you will create the circuit.
Step 2.
to verify that sufficient VLAN capacity is available. (You will
Chapter 6 Create Circuits and VT Tunnels
8 through 20 with the correct
for each node that
for each node that carries the
20-8. If not, continue with
"DLP-A99 Determine
Step 3.
August 2005