Ntp- A148 Create A Manual Cross-Connect For A G-Series Or E-Series Card In Port-Mapped Mode - Cisco ONS 15454 Series Procedure Manual

Chapter 6 Create Circuits and VT Tunnels
State—The circuit is in service (default).
•
Apply to drop ports—Uncheck this box.
•
Protected Drops—Leave the default unchanged (unchecked).
•
If the circuit will be routed on a path protection, complete the
Step 9
Selectors" task on page
Click Next.
Step 10
Provision the circuit source:
Step 11
a. From the Node drop-down list, choose the circuit source node.
b. From the Slot drop-down list, choose the Ethernet card that will be the cross-connect source.
From the Port drop-down list, choose the cross-connect source port.
c.
Click Next.
Step 12
Provision the circuit destination:
Step 13
From the Node drop-down list, choose the cross-connect source node selected in
a.
Ethernet cross-connects, the source and destination nodes are the same.)
From the Slot drop-down list, choose the OC-N card that connects to the non-ONS equipment.
b.
Depending on the OC-N card, choose the port and STS from the Port and STS drop-down lists.
c.
Click Next.
Step 14
In the left pane of the Circuit Routing Preferences panel, confirm that the following information is
Step 15
correct:
Circuit name
•
• Circuit type
• Circuit size
ONS nodes
•
If the information is not correct, click the Back button and repeat Steps
Step 16
information. If the information is correct, check Route Automatically.
Click Finish.
Step 17
Complete the
Step 18
Stop. You have completed this procedure.
August 2005
NTP-A148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode
19-12.
"NTP-A149 Test G-Series Circuits" procedure on page
"DLP-A218 Provision Path Protection
5 through 15
6-81.
Cisco ONS 15454 Procedure Guide, R5.0
Step 11. (For
with the correct
6-77