Ntp- A16 Install The Oc-N Cards - Cisco ONS 15454 Series Procedure Manual

NTP-A16 Install the OC-N Cards
Table 2-2 Card and Slot Compatibility for the XC10G Card (continued)
Slot 1
Type MS
OC48 IR/STM16 X
SH AS 1310
OC48 LR/STM16 X
LH AS 1550
OC48-ELR/STM1
6 EH 100 GHz
OC48 ELR 200
GHz
OC192
SR/STM64 IO
1310
OC192 IR/STM64
SH 1550
OC192
LR/STM64 LH
1550
OC192
LR/STM64 LH
ITU 15xx.xx
FC_MR-4 X
1. This identifies 1:N cards that operate as normal DS1 or DS3 cards when installed in certain slots.
2. This DS3 card cannot be used in this slot if used with a high-density EIA or in a 1:N configuration.
Stop. You have completed this procedure.
NTP-A16 Install the OC-N Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Cisco ONS 15454 Procedure Guide, R5.0
2-6
2 3 4 5 6
MS MS MS HS HS
X X X X X
X X X X X
X X
X X
X X
X X
X X
X X
X X X X X
This procedure describes how to install optical (OC-N) cards (OC-3,
OC-12, OC-48, and OC-192).
OC-3, OC-12, OC-48, and OC-192 cards (as applicable)
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
7 8 9 10 11
TCC XC AIC XC TCC HS
Chapter 2 Install Cards and Fiber-Optic Cable
12 13 14 15
HS MS MS
X X X X
X X X X
X X
X X
X X
X X
X X
X X
X X X X
16 17
MS MS
X X
X X
X X
May 2006