Dlp- A168 Change Line And Threshold Settings For The Ds3Xm-6 Card - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
DLP-A168 Change Line and Threshold Settings for the DS3XM-6 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The DS3XM-6 (transmux) card can accept up to six channelized DS-3 signals and convert each signal
Note
to 28 VT1.5 signals. Conversely, the card can take 28 T-1s and multiplex them into a channeled C-bit or
M13 framed DS-3.
In node view, double-click the DS3XM-6 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds tab.
Note
Modify any of the settings found under these subtabs. For definitions of the Line settings, see
Step 4
Table
Electrical Path Threshold settings, see
see
Click Apply.
Step 5
Repeat Steps
Step 6
Table 18-15
Table 18-15
Parameter
Port #
Port Name
SF BER
March 2007
This task changes the line and threshold settings for the DS3XM-6 card.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
See Chapter 7, "Manage Alarms"
18-15. For definitions of the Line Threshold settings, see
Table 18-18.
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS3XM-6 cards.
Line Options for the DS3XM-6 Parameters
Description
(Display only.) Sets the port
number.
Sets the port name.
Sets the signal fail bit error rate.
DLP-A168 Change Line and Threshold Settings for the DS3XM-6 Card
for information about the Alarm Behavior tab.
Table
Table 18-17. For definitions of the SONET Threshold settings,
Options
1 to 6
User-defined, up to 32 alphanumeric/ special
characters. Blank by default.
See the "DLP-A314 Assign a Name to a Port" task on
page 20-8.
1E-3
•
1E-4
•
1E-5
•
Cisco ONS 15454 Procedure Guide, R5.0
18-16. For definitions of the
18-41