Chapter 1
Install the Shelf and Backplane Cable
Figure 1-11
EIA Labelling on the Mounting Bar
Mounting holes
for all other EIAs
UBIC-V/UBIC-H
mounting hole
Tighten the two screws (48-2116-01) for each mounting bar.
Step 6
Repeat Steps
Step 7
Attach the rear cover (700-06029-XX) by hanging it from the mounting screws on the back of the
Step 8
mounting bars and pulling it down until it fits firmly into place
(Figure
March 2005
5
and
6
for the second mounting bar.
1-13).
NTP-A11 Install the Rear Cover
UBIC-H
mounting hole
UBIC-V
mounting hole
(Figure
1-12) or by using standoffs
Cisco ONS 15454 Procedure Guide, R5.0
1-27