Table 18-16 Line Threshold Options For The Ds3Xm-6 Card - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Table 18-15
Parameter
Service State Identifies the autonomously
AINS Soak
Table 18-16
Table 18-16
Parameter
Port
CV
ES
SES
LOSS
Table 18-17
cards.
March 2007
Line Options for the DS3XM-6 Parameters (continued)
Description
generated state that gives the
overall condition of the port.
Service states appear in the
format: Primary State-Primary
State Qualifier, Secondary State.
Sets the automatic in-service
soak period.
lists the line threshold options for DS3XM-6 cards.
Line Threshold Options for the DS3XM-6 Card
Description
(Display only.) Port number
Coding violations
Errored seconds
Severely errored seconds
Loss of signal seconds
describes the values on the Provisioning > Elect Path Thresholds tabs for the DS3XM-6
DLP-A168 Change Line and Threshold Settings for the DS3XM-6 Card
Options
IS-NR—(In-Service and Normal) The port is
•
fully operational and performing as provisioned.
OOS-AU,AINS—(Out-Of-Service and
•
Autonomous, Automatic In-Service) The port is
out-of-service, but traffic is carried. Alarm
reporting is suppressed. The ONS node monitors
the ports for an error-free signal. After an
error-free signal is detected, the port stays in
OOS-AU,AINS state for the duration of the soak
period. After the soak period ends, the port
service state changes to IS-NR.
OOS-MA,DSBLD—(Out-of-Service and
•
Management, Disabled) The port is
out-of-service and unable to carry traffic.
OOS-MA,MT—(Out-of-Service and
•
Management, Maintenance) The port is
out-of-service for maintenance. Alarm reporting
is suppressed, but traffic is carried and
loopbacks are allowed.
Duration of valid input signal, in hh.mm format,
•
after which the card becomes in service (IS)
automatically
0 to 48 hours, 15-minute increments
•
Options
1 to 6
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds.
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds.
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds.
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds.
Cisco ONS 15454 Procedure Guide, R5.0
18-43