Dlp- A191 Delete A Card - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Use a Phillips screwdriver to install the six perimeter screws and bracket screws (P/N 48-0422-01) at
Step 8
8 to 10 lb-in. (9.2 to 11.5kgf-cm) to secure the cover panel to the backplane
Install the alarm and timing panel cover and insert and tighten the last perimeter screw.
Figure 18-10
Figure 18-10
Return to your originating procedure (NTP).
Step 9
DLP-A191 Delete a Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2007
shows a UBIC-V EIA installation.
Installing the UBIC-V EIA
This task deletes a card from CTC.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
DLP-A191 Delete a Card
(Figure 18-8 on page
Cisco ONS 15454 Procedure Guide, R5.0
18-64).
18-65