Ntp- A224 Provision An Open-Ended Path Protection - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:

Table of Contents

NTP-A224 Provision an Open-Ended Path Protection

Verify that the fiber is correctly connected to the path protection trunk (span) OC-N cards at each

open-ended path protection node.

Nodes 2 and 3 through Slots 12 and 5. Trunk cards at Nodes 2 and 3 are connected to the third-party

vendor equipment.

Verify that the third-party cards or units to which the ONS 15454 trunk cards are connected are the same

OC-N rate as the ONS 15454 trunk cards. The third-party time slots must match the ONS 15454 card

time slots to which they are connected. For example, if your trunk card is an OC-48, the third-party

vendor card or unit must have STSs 1 to 48 available.

Log into an ONS 15454 in the path protection you are turning up. See the

task on page

Complete the

cards/ports that are connected to another ONS 15454. (Alternatively, if additional bandwidth is needed

for CTC management, complete

Cisco ONS 15454 Procedure Guide, R5.0

ONS 15454 Open-Ended Path Protection Configurations Fiber Connection Example

17-66. If you are already logged in, continue with Step 4.

"DLP-A377 Provision Section DCC Terminations" task on page 20-61

the"DLP-A378 Provision Line DCC Terminations" task on

shows an example. Node 1 is connected to ONS 15454

Turn Up Network

"DLP-A60 Log into CTC"

for the ONS 15454

December 2004

Chapters

Table of Contents