Dlp- A2 Inspect The Shelf Assembly - Cisco ONS 15454 Series Procedure Manual

DLP-A2 Inspect the Shelf Assembly
DLP-A2 Inspect the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Open the shelf using the pinned hex key. For more information, see the
task on page
Step 2 Verify the following:
•
•
If the pins are bent or broken or the frame is bent, call your Cisco sales engineer for a replacement.
Step 3
Close the front door before installing.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A3 Reverse the Mounting Bracket to Fit a 19-inch (482.6 mm) Rack
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Use only the fastening hardware provided with the ONS 15454 to prevent loosening, deterioration, and
Caution
electromechanical corrosion of the hardware and joined material.
When mounting the ONS 15454 in a frame with a nonconductive coating (such as paint, lacquer, or
Caution
enamel) either use the thread-forming screws provided with the ONS 15454 shipping kit, or remove the
coating from the threads to ensure electrical continuity.
Cisco ONS 15454 Procedure Guide, R5.0
17-2
This task verifies that all parts of the shelf assembly are in good condition.
Pinned hex (Allen) key for front door
DLP-A1 Unpack and Verify the Shelf Assembly, page 17-1
Required
Onsite
None
17-8.
The pins are not bent or broken.
The frame is not bent.
This task installs the mounting bracket to convert a 23-inch (584.2 mm)
rack to a 19-inch (482.6 mm) rack.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
As needed
Onsite
None
Chapter 17 DLPs A1 to A99
"DLP-A8 Open the Front Door"
March 2005