Dlp- A522 Suppress Alarm Reporting - Cisco ONS 15454 Series Procedure Manual

Chapter 22 DLPs A500 to A599
Figure 22-8
When filtering is enabled, conditions in the Show list are visible and conditions in the Hide list are
invisible.
•
•
•
•
Click Apply and OK.
Step 6
Alarm and condition filtering parameters are enforced when alarm filtering is enabled (see the
"DLP-A225 Enable Alarm Filtering" task on page
disabled (see the
Return to your originating procedure (NTP).
Step 7
DLP-A522 Suppress Alarm Reporting
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
October 2005
Alarm Filter Dialog Box Conditions Tab
To move conditions individually from the Show list to the Hide list, click the > button.
To move conditions individually from the Hide list to the Show list, click the < button.
To move conditions collectively from the Show list to the Hide list, click the >> button.
To move conditions collectively from the Hide list to the Show list, click the << button.
Conditions include alarms.
Note
"DLP-A227 Disable Alarm Filtering" task on page
This task suppresses the reporting of ONS 15454 alarms at the node, card,
or port level.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
DLP-A522 Suppress Alarm Reporting
19-17), and are not enforced when alarm filtering is
19-17).
Cisco ONS 15454 Procedure Guide, R5.0
22-17