Cisco ONS 15454 Series Procedure Manual page 227

Chapter 6 Create Circuits and VT Tunnels
Click Next.
Step 22
In the left pane of the Circuit Routing Preferences panel, confirm that the following information is
Step 23
correct:
•
•
•
•
Step 24 If the information is not correct, click the Back button and repeat Steps
information. If the information is correct, check Route Automatically.
Click Finish.
Step 25
Step 26 Complete the
page
Step 27 Complete the
Stop. You have completed this procedure.
NTP-A192 Create a Circuit for an E-Series Card in Port-Mapped
Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
If you are already logged in, continue with
Provision the Ethernet cards that will carry the circuit for port-mapped mode. See the
Step 2
Provision E-Series Ethernet Card Mode" task on page
Step 3 Complete the
From the View menu, choose Go to Network View.
Step 4
Click the Circuits tab and click Create.
Step 5
In the Create Circuits dialog box, complete the following fields:
Step 6
•
•
•
August 2005
Circuit name
Circuit type
Circuit size
ONS nodes
"DLP-A221 Provision E-Series Ethernet Ports for VLAN Membership" task on
19-14.
"NTP-A146 Test E-Series Circuits" procedure on page
This procedure creates an E-Series point-to-point SONET circuit with an
E-Series card in port-mapped mode.
An E-Series Ethernet card must be installed at each end of the circuit and
configured in port-mapped mode.
NTP-A127 Verify Network Turn Up, page 6-4
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A220 Provision E-Series Ethernet Ports" task on page
Circuit Type—Choose STS.
Number of Circuits—Leave the default unchanged (1).
Auto-ranged—Unavailable.
NTP-A192 Create a Circuit for an E-Series Card in Port-Mapped Mode
at the node where you will create the circuit.
Step 4.
19-29.
Cisco ONS 15454 Procedure Guide, R5.0
8 through 23 with the correct
6-72.
"DLP-A246
19-13.
6-59