Ntp- A30 Create Users And Assign Security - Cisco ONS 15454 Series Procedure Manual

NTP-A30 Create Users and Assign Security
NTP-A30 Create Users and Assign Security
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with
Note
Complete the
Step 2
Create a New User on Multiple Nodes" task on page 17-83
Note
If you want to modify the security policy settings, including password aging and idle user timeout
Step 3
policies, complete the
Stop. You have completed this procedure.
NTP-A25 Set Up Name, Date, Time, and Contact Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
Click the Provisioning > General tabs.
Step 2
Cisco ONS 15454 Procedure Guide, R5.0
4-4
This procedure creates ONS 15454 users and assigns their security levels.
None
NTP-A24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Superuser
"DLP-A60 Log into CTC" task on page 17-66
You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 can be used to set up other ONS 15454 users. You can add up to 500 users to one
ONS 15454.
"DLP-A74 Create a New User on a Single Node" task on page 17-82
You must add the same user name and password to each node a user will access.
"NTP-A205 Modify Users and Change Security" procedure on page
This procedure provisions identification information for the node,
including the node name, a contact name and phone number, the location
of the node, and the date, time, and time zone.
None
NTP-A24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
at the node where you need to create users.
Step 2.
as needed.
for the node you will turn up. If you are
Chapter 4 Turn Up Node
or the "DLP-A75
10-6.
December 2004