Table 18-19 Line Options For The Ec1-12 Card - Cisco ONS 15454 Series Procedure Manual

DLP-A169 Change Line and Threshold Settings for the EC1-12 Card
Click Apply.
Step 5
Repeat Steps
Step 6
Table 18-19
Table 18-19
Parameter
Port #
Port Name
SF BER
SD BER
PJStsMon#
Line Buildout
Rx
Equalization
Admin State
Cisco ONS 15454 Procedure Guide, R5.0
18-46
3 through 5 for each subtab that has parameters you want to provision.
describes the values on the Line tab for the EC1-12 card.
Line Options for the EC1-12 Card
Description
(Display only.) Displays the EC-1
card port number.
Sets a name for the port (optional). User-defined, up to 32 alphanumeric/ special
Sets the signal fail bit error rate.
Sets the signal degrade bit error
rate.
Sets the STS that will be used for
pointer justification; if set to zero,
no STS is used.
Defines the distance (in feet) from
backplane to next termination
point.
For early EC1-12 card versions,
equalization can be turned off if
the line length is short or the
environment is extremely cold; Rx
Equalization should normally be
set to On.
Sets the port service state unless
network conditions prevent the
change.
Chapter 18
Options
1 to 12
characters. Blank by default.
See the "DLP-A314 Assign a Name to a Port"
task on page 20-8.
1E-3
•
1E-4
•
1E-5
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
0 (default)
•
1
•
0 - 225 (default)
•
226 - 450
•
On (checked, default)
•
Off (unchecked)
•
IS—Puts the port in-service. The port
•
service state changes to IS-NR.
IS,AINS—Puts the port in automatic
•
in-service. The port service state changes to
OOS-AU,AINS.
OOS,DSBLD—Removes the port from
•
service and disables it. The port service
state changes to OOS-MA,DSBLD.
OOS,MT—Removes the port from service
•
for maintenance. The port service state
changes to OOS-MA,MT.
DLPs A100 to A199
March 2007