Figure 18-2 Node View Conditions Window; Dlp- A114 View Conditions - Cisco ONS 15454 Series Procedure Manual

DLP-A114 View Conditions
DLP-A114 View Conditions
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the card, node, or network view, click the Conditions tab.
Step 1
Click Retrieve
Step 2
The Retrieve button requests the current set of fault conditions from the node, card, or network. The
window is not updated when events change on the node. You must click Retrieve to see any changes.
Figure 18-2
Conditions include all fault conditions raised on the node, whether or not they are reported.
Note
Events that are reported as Major (MJ), Minor (MN), or Critical (CR) severities are alarms. Events that
are reported as Not Alarmed (NA) are conditions. Conditions that are not reported at all are marked NR
in the Conditions window severity column. Conditions that have a default severity of CR, MJ, MN, or
NA but are not reported due to exclusion or suppression are shown as NR in the Conditions window.
Cisco ONS 15454 Procedure Guide, R5.0
18-4
This task is used to view conditions (events with a Not Reported [NR]
severity) at the card, node, or network level. Conditions give you a clear
record of changes or events that do not result in alarms.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
(Figure 18-2).
Node View Conditions Window
Alarms can be unreported when they are filtered out of the display. See the
Alarm Filtering" task on page 19-17 for information.
Chapter 18 DLPs A100 to A199
"DLP-A225 Enable
March 2007