Dlp- A364 Reset The Tcc2/Tcc2P Card Using Ctc - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Note
From the View menu, choose Go to Other Node.
Step 6
In the Select Node dialog box, choose the next node that you want to add to the BLSR.
Step 7
Repeat Steps
Step 8
added, continue with
From the View menu, choose Go to Network View. After 10 to 15 seconds, verify the following:
Step 9
•
•
Return to your originating procedure (NTP).
Step 10
DLP-A364 Reset the TCC2/TCC2P Card Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard. Statement 206
Before you reset the TCC2/TCC2P card, you should wait at least 60 seconds after the last provisioning
Note
change you made to avoid losing any changes to the database.
When a software reset is performed on an active TCC2/TCC2P card, the AIC or AIC-I card goes through
Note
an initialization process and also resets. The AIC or AIC-I card reset is normal and happens each time
an active TCC2/TCC2P card goes through a software-initiated reset.
Complete the
Step 1
TCC2/TCC2P card. If you are already logged in, continue with
In node view, right-click the TCC2/TCC2P card to reveal a shortcut menu.
Step 2
Click Reset Card.
Step 3
March 2005
Some or all of the following alarms will appear until all the BLSR nodes are provisioned: E-W
MISMATCH, RING MISMATCH, APSCIMP, APSDFLTK, and BLSROSYNC. The alarms will
clear after you configure all the nodes in the BLSR.
1 through 7 at each node that you want to add to the BLSR. When all nodes have been
Step 9.
A green span line appears between all BLSR nodes.
All E-W MISMATCH, RING MISMATCH, APSCIMP, DFLTK, and BLSROSYNC alarms are
cleared.
This task resets the TCC2/TCC2P card and switches the node to the
redundant card.
None
DLP-A36 Install the TCC2/TCC2P Cards, page 17-42
As needed
Onsite or remote
Superuser
"DLP-A60 Log into CTC" task on page 17-66
DLP-A364 Reset the TCC2/TCC2P Card Using CTC
at the node where you want to reset the
Step 2.
Cisco ONS 15454 Procedure Guide, R5.0
20-49