Ntp- A210 Convert A Path Protection To A Two-Fiber Blsr Manually - Cisco ONS 15454 Series Procedure Manual

NTP-A210 Convert a Path Protection to a Two-Fiber BLSR Manually
If the first half of the capacity is exceeded, this procedure cannot be completed. Bandwidth must be
Caution
50 percent unassigned to convert to BLSR. Refer to local procedures for relocating circuits if these
requirements are not met.
Repeat Steps
Step 6
nodes comply with
Save all circuit information:
Step 7
a. In network view, click the Circuits tab.
b. Record the circuit information using one of the following options:
Step 8 Delete the circuits:
a. In network view, click the Circuits tab. All circuits on the ring appear.
With the Ctrl key pressed, click each circuit. Each line turns dark blue as it is selected.
b.
After all circuits have been selected, click Delete. Allow several minutes for processing; the actual
c.
length of time depends on the number of circuits in the network.
Complete the
Step 9
To recreate the circuits, see
Step 10
procedure for the circuit type you want to enter.
Note
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
13-16
1 through 5 for each node in the path protection that you will convert to a BLSR. When all
Step 5, continue with the next step.
From the File menu, click Print to print the circuits table. See the
•
task on page 22-5 for more information.
From the File menu, click Export and choose the data format: HTML, CSV (comma separated
•
values), or TSV (tab separated values). Click OK and save the file in a temporary directory. See
the "DLP-A516 Export CTC Data" task on page 22-6
"NTP-A126 Create a BLSR" procedure on page 5-12
Chapter 6, "Create Circuits and VT Tunnels."
To add additional nodes to a BLSR, see the
page 14-2.
Chapter 13 Convert Network Configurations
"DLP-A515 Print CTC Data"
for more information.
to create the BLSR.
and choose the applicable
"NTP-A212 Add a BLSR Node" procedure on
December 2004