Dlp- A385 Delete A Member From A Vcat Circuit - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
DLP-A385 Delete a Member from a VCAT Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting a member from a non-LCAS circuit can be service-affecting.
Note
Deleting SW-LCAS or LCAS members in the IS-NR or OOS-AU,AINS service state can be service
Note
affecting. Cisco recommends putting the member to be deleted in the OOS-MA,OOG service state
before deleting. Non-LCAS members do not support the OOS-MA,OOG service state.
You cannot delete members that have a source or destination on an ML-Series or FC_MR-4 (line rate
Note
mode) card.
In node or network view, click the Circuits tab.
Step 1
Click the VCAT circuit that you want to edit, then click Edit.
Step 2
Click the Members tab.
Step 3
Select the member that you want to delete. To select multiple members, press Ctrl and click the desired
Step 4
members.
Click Delete Member.
Step 5
In the confirmation dialog box, click Yes.
Step 6
Return to your originating procedure (NTP).
Step 7
March 2005
This task removes a member from a VCAT circuit created with the
following criteria:
SW-LCAS VCAT circuits on FC_MR-4 (enhanced mode) cards
•
Non-LCAS and LCAS circuits on CE-100T-8 cards
•
This task reduces the size of the VCAT circuit.
FC_MR-4 card (enhanced mode) or CE-100T-8 card
DLP-A60 Log into CTC, page 17-66
VCAT circuits must exist on the network. See the
Automatically Routed VCAT Circuit" procedure on page 6-86
"NTP-A265 Create a Manually Routed VCAT Circuit" procedure on
page 6-90.
As necessary, complete the
State" task on page 21-15
to OOS-MA,OOG.
As needed
Onsite or remote
Provisioning or higher
DLP-A385 Delete a Member from a VCAT Circuit
"NTP-A264 Create an
"DLP-A437 Change a VCAT Member Service
to change a SW-LCAS or LCAS member state
Cisco ONS 15454 Procedure Guide, R5.0
or the
20-69