Dlp- A96 Provision A Ds-1 Or Ds-3 Circuit Route - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
on the same network chooses the same port, STS, VT, or DS1as you simultaneously, one of you receives
a Path in Use error and is unable to complete the circuit. The user with the partial circuit needs to choose
new destination parameters.
If you need to create a secondary destination, for example, a path protection bridge/selector circuit exit
Step 10
point in a multivendor path protection, click Use Secondary Destination and repeat Steps
to define the secondary destination.
Step 11 Click Next.
Return to your originating procedure (NTP).
Step 12
DLP-A96 Provision a DS-1 or DS-3 Circuit Route
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the Route Review/Edit area of the Circuit Creation wizard, click the source node icon if it is not
already selected.
Step 2 Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source STS and VT (DS-1 circuit only) appear.
If you want to change the source STS, adjust the Source STS field; otherwise, continue with
Step 3
Step 4 If you want to change the source VT for DS-1 circuits, adjust the Source VT field; otherwise, continue
with
Note
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 5
If the Fully Protect Path check box is checked in the Circuit Routing Preferences area, you must:
Step 6
•
•
•
Repeat Steps
Step 7
all intermediary nodes.
March 2005
This task provisions the circuit route for manually routed DS-1 or DS-3
circuits.
None
DLP-A60 Log into CTC, page 17-66
The Circuit Creation wizard Route Review and Edit panel must be open.
As needed
Onsite or remote
Provisioning or higher
Step 5.
VT is gray (unavailable) for DS-3 circuits.
Add two spans for all path protection or unprotected portions of the circuit route from the source to
the destination.
Add one span for all BLSR or 1+1 portions of route from the source to the destination.
For circuits routed on path protection DRI topologies, provision the working and protect paths as
well as spans between the DRI nodes.
2 through 6 until the circuit is provisioned from the source to the destination node through
DLP-A96 Provision a DS-1 or DS-3 Circuit Route
Cisco ONS 15454 Procedure Guide, R5.0
7 through 9
Step 4.
17-97