Dlp- A177 Convert Ds3-12 Cards From 1:1 To 1:N Protection - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Physically insert a DS1N-14 card into the same slot.
Step 13
Verify that the card boots up properly.
Step 14
Click the Inventory tab and verify that the new card appears as a DS1N-14.
Step 15
Click the Provisioning > Protection tabs.
Step 16
Click Create.
Step 17
Type a name for the protection group in the Name field (optional).
Step 18
From the Type drop-down list, choose 1:N (card).
Step 19
From the Protect Card drop-down list, choose the DS1N-14 card. Verify that the correct DS1N-14 card
Step 20
appears in the Protect Card field.
In the Available Cards list, highlight the cards that you want in the protection group. Click the arrow
Step 21
(>>) button to move the cards to the Working Cards list.
If necessary, select a new reversion time in the Reversion time drop-down list.
Step 22
Note
Click OK. The protection group appears in the Protection Groups list on the Protection subtab.
Step 23
Return to your originating procedure (NTP).
Step 24
DLP-A177 Convert DS3-12 Cards From 1:1 to 1:N Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure assumes that DS3-12 cards are installed in Slots 1 to 6 and/or Slots 12 to 17. The DS3-12
Note
cards in Slots 3 or 15, which are the protection slots, will be replaced with DS3N-12 cards.
In node view, click the Maintenance > Protection tabs.
Step 1
Click the protection group containing Slot 3 or Slot 15 (where you will install the DS3N-12 card).
Step 2
Make sure the slot you are upgrading is not carrying working traffic. In the Selected Group list, the
Step 3
protect slot must say Protect/Standby as shown
protect slot status is Protect/Active, switch traffic to the working card:
a.
March 2007
1:N protection groups are always revertive.
This task converts DS3-12 cards in 1:1 protection to 1:N protection. A 1:N
protection group can protect a maximum of five working cards.
CTC Software R2.0 or later
At least on DS3N-12 card and a protection group with DS3-12 cards.
DLP-A60 Log into CTC, page 17-66
As needed
Onsite
Provisioning or higher
Under Selected Group, click the protect card.
DLP-A177 Convert DS3-12 Cards From 1:1 to 1:N Protection
Figure 18-5 on page 18-56, and not Protect/Active. If the
Cisco ONS 15454 Procedure Guide, R5.0
18-57