Before You Begin - Cisco ONS 15454 Series Procedure Manual

Monitor Performance
This chapter explains how to enable and view performance monitoring statistics for the
Cisco ONS 15454. Performance monitoring (PM) parameters are used by service providers to gather,
store, and set thresholds and report performance data for early detection of problems. For more PM
information, details, and definitions refer to the Cisco ONS 15454 Troubleshooting Guide.

Before You Begin

Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
For additional information regarding PM parameters, refer to the Digital transmission surveillance
Note
section in Telcordia's GR-1230-CORE, GR-820-CORE, GR-499-CORE, and GR-253-CORE
documents, and in the ANSI document entitled Digital Hierarchy - Layer 1 In-Service Digital
Transmission Performance Monitoring.
December 2004
NTP-A253 Change the PM Display, page
counts.
NTP-A122 Monitor Electrical Performance, page
performance.
NTP-A198 Monitor Ethernet Performance, page
performance.
NTP-A279 Create or Delete Ethernet RMON Thresholds, page
or delete Ethernet remote monitoring (RMON) thresholds.
NTP-A250 Monitor OC-N Performance, page
performance.
NTP-A285 Monitor FC_MR-4 Performance, page
performance.
NTP-A289 Create or Delete FC_MR-4 RMON Thresholds, page
or delete FC_MR-4 RMON thresholds.
C H A P T E R
8-2—Complete as needed to change the displayed PM
8-3—Complete as needed to monitor electrical
8-5—Complete as needed to monitor Ethernet
8-5—Complete as needed to create
8-6—Complete as needed to monitor optical (OC-N)
8-7—Complete as needed to monitor FC_MR-4
8-7—Complete as needed to create
Cisco ONS 15454 Procedure Guide, R5.0
8
8-1