Figure 18-11 Circuits On Span Dialog Box With A Force Switch - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
From the View menu, choose Go to Network View.
Step 1
Right-click the span where you want to switch path protection traffic away. Choose Circuits from the
Step 2
shortcut menu.
In the Circuits on Span dialog box, choose FORCE SWITCH AWAY. Click Apply.
Step 3
In the Confirm UPSR Switch dialog box, click Yes.
Step 4
In the Protection Switch Result dialog box, click OK.
Step 5
In the Circuits on Span window, the Switch State for all circuits is FORCE.
example.
Figure 18-11
Note
Return to your originating procedure (NTP).
Step 6
March 2007
Circuits on Span Dialog Box with a Force Switch
A Force switch request on a span or card causes CTC to raise a FORCED-REQ condition. The
condition clears when you clear the Force switch.
DLP-A197 Initiate a Path Protection Force Switch
Figure 18-11
Cisco ONS 15454 Procedure Guide, R5.0
shows an
18-69