Dlp- A52 Set Up A Windows Pc For Craft Connection To An Ons 15454 Using Automatic Host Detection - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
DLP-A52 Set Up a Windows PC for Craft Connection to an ONS 15454 Using
Automatic Host Detection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the operating system that is installed on your computer:
Step 1
a.
b.
c.
According to the Windows operating system installed on your computer, perform one of the following
Step 2
steps:
•
•
•
•
Step 3 If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a.
b.
c.
d.
e.
March 2005
DLP-A52 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Automatic Host Detection
This task sets up your computer for local craft connection to the
ONS 15454 when:
•
•
•
•
None
NTP-A260 Set Up Computer for CTC, page 3-1
As needed
Onsite
None
From the Windows Start menu, choose Settings > Control Panel.
In Windows XP, you can select Control Panel directly from the Start menu. Make sure you
Note
are in Classic View before continuing with this procedure.
In the Control Panel window, double-click the System icon.
On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP.
For Windows 98, complete
For Windows NT 4.0, complete
For Windows 2000, complete
For Windows XP, complete
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel dialog box, click the Network icon.
In the Network dialog box, select TCP/IP for your NIC, then click Properties.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
Click the WINS Configuration tab and choose Disable WINS Resolution.
You will connect to the ONS 15454 Ethernet port or backplane LAN
pins either directly or through a hub.
All nodes that you will access are running Software Release 3.3 or
later.
You will connect to multiple ONS 15454s and do not want to
reconfigure your IP address each time.
You do not need to access non-ONS 15454 applications such as ping
and tracert (trace route).
Step 3.
Step 4.
Step 5.
Step 6.
Cisco ONS 15454 Procedure Guide, R5.0
17-61