Ntp- A169 Set Up Ctc Network Access - Cisco ONS 15454 Series Procedure Manual

Chapter 4 Turn Up Node
To change the extreme high battery voltage threshold in 0.5 VDC increments, choose a voltage from the
Step 6
EHIBATVGVdc drop-down list.
Click Apply.
Step 7
Stop. You have completed this procedure.
NTP-A169 Set Up CTC Network Access
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step
Step 2 Complete the
address, subnet mask, default router, DHCP server, IIOP listener port, and SOCKS proxy server settings.
Tip
If you want to turn on the ONS 15454 secure mode, which allows two IP addresses to be provisioned for
Step 3
the node if TCC2P cards are installed, complete the
page
If static routes are needed, complete the
Step 4
the "CTC Network Connectivity" chapter in the Cisco ONS 15454 Reference Manual for further
information about static routes.
Step 5 If the ONS 15454 is connected to a LAN or WAN that uses OSPF and you want to share routing
information between the LAN/WAN and the ONS network, complete the
Open Shortest Path First Protocol" task on page
If the ONS 15454 is connected to a LAN or WAN that uses RIP, complete the
Step 6
Change Routing Information Protocol" task on page
Stop. You have completed this procedure.
December 2004
This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, SOCKS proxy
server settings, static routes, Open Shortest Path First (OSPF) protocol,
and Routing Information Protocol (RIP).
None
NTP-A24 Verify Card Installation, page 4-2
Required
Onsite or remote
Superuser
"DLP-A60 Log into CTC" task on page
2.
"DLP-A249 Provision IP Settings" task on page 19-30
If you cannot log into the node, you can change its IP address, default router, and network mask
by using the LCD on the ONS 15454 fan-tray assembly (unless LCD provisioning is
suppressed). See the "DLP-A64 Set the IP Address, Default Router, and Network Mask Using
the LCD" task on page 17-71
any other network settings.
21-11.
17-66. If you are already logged in, continue with
for instructions. However, you cannot use the LCD to provision
"DLP-A433 Enable Node Security Mode" task on
"DLP-A65 Create a Static Route" task on page
19-34.
19-36.
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A169 Set Up CTC Network Access
to provision the ONS 15454 IP
17-73. Refer to
"DLP-A250 Set Up or Change
"DLP-A251 Set Up or
4-7