Dlp- A190 Install A Ubic-V Eia - Cisco ONS 15454 Series Procedure Manual

Chapter 18 DLPs A100 to A199
Verify that the working slot does not revert to Standby, which might indicate a problem on the working
Step 6
span.
Return to your originating procedure (NTP).
Step 7
DLP-A190 Install a UBIC-V EIA
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Always use an electrostatic discharge (ESD) wristband when working with a powered ONS 15454. Plug
Caution
the wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
UBIC-V EIAs can only be installed on shelf assembly 15454-SA-HD. 15454-SA-HD shelf assemblies
Note
are differentiated from other shelf assemblies by the blue hexagon symbol, which indicates the available
high-density slots, found under Slots 1 through 3 and 15 through 17.
UBIC-V or UBIC-H EIAs are required when using high-density (48-port DS-3 and 12-port DS3XM)
Note
electrical cards.
Locate the correct UBIC-V EIA for the side you want to install and remove the UBIC EIA-V from the
Step 1
packaging.
Verify that none of the pins on the UBIC EIA are bent.
Step 2
If present, remove the yellow connector protectors.
Step 3
If screws are present in the alignment standoff holes, use a Phillips screwdriver to remove them.
Step 4
Use a flathead screwdriver or 5/16-inch deep socket wrench to tighten the standoffs at 8 to 10 inch
Step 5
pound-force (lb-in) (9.2 to 11.5 centimeter kilogram-force[kgf-cm]).
standoffs installed on the shelf.
March 2007
This task installs a Universal Backplane Interface Connector—Vertical
(UBIC-V) EIA.
#2 Phillips screwdriver
Small slot-head screwdriver
6 perimeter screws, 6-32 x 0.375-inch Phillips head (P/N 48-0422-01)
UBIC-V, A side (15454-EIA-UBICV-A) EIA panel and/or UBIC-V, B side
(15454-EIA-UBICV-B) EIA panel
As needed
Onsite
None
DLP-A190 Install a UBIC-V EIA
Figure 18-6 shows the alignment
Cisco ONS 15454 Procedure Guide, R5.0
18-61