Cisco ONS 15454 Series Procedure Manual page 613

Chapter 19 DLPs A200 to A299
Table 19-2 LED Behavior During TCC2/TCC2P Reboot
Reboot Activity
Standby TCC2/TCC2P card updated
with new network information.
Memory test (1 to 2 minutes).
If an AIC or AIC-I card is installed,
AIC FAIL and alarm LEDs light up
briefly when the AIC is updated.
The standby TCC2/TCC2P becomes
the active TCC2/TCC2P.
Memory test (1 to 2 minutes).
TCC2/TCC2P updated with new
network information.
The active TCC2/TCC2P becomes the
standby TCC2/TCC2P.
Click OK. The network view appears. The node icon appears in gray, during which time you cannot
Step 5
access the node.
Double-click the node icon when it becomes green.
Step 6
Return to your originating procedure (NTP).
Step 7
September 2005
Active TCC2/TCC2P LEDs
ACT/STBY: Flashing green.
1. All LEDs: Turn off (1 to 2 minutes).
CTC displays "Lost node connection,
switching to network view" message.
FAIL LED: Solid red.
2.
3. FAIL LED: Flashing red.
4. All LEDs on except ACT/STBY.
CRIT turns off.
5.
MAJ and MIN turn off.
6.
REM, SYNC, and ACO turn off; all
7.
LEDs are off.
ACT/STBY: Solid yellow.
8.
ACT/STBY: Flashing yellow.
9.
ACT/STBY: Solid yellow.
10.
DLP-A249 Provision IP Settings
Standby TCC2/TCC2P LEDs
ACT/STBY: Flashing yellow.
1.
FAIL LED: Solid red.
2.
All LEDs on except ACT/STBY.
3.
CRIT turns off.
4.
MAJ and MIN turn off.
5.
6. REM, SYNC, and ACO turn off.
7. All LEDs (except A&B PWR)
turn off (1 to 2 minutes).
8. ACT/STBY: Solid yellow.
9. Alarm LEDs: Flash once.
ACT/STBY: Solid green.
10.
ACT/STBY: Solid green.
Cisco ONS 15454 Procedure Guide, R5.0
19-33