Dlp- A435 Modify Backplane Port Ip Settings - Cisco ONS 15454 Series Procedure Manual

Chapter 21 DLPs A400 to A499
DLP-A435 Modify Backplane Port IP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Provisioning an IP address that is incompatible with the ONS 15454 network might be service affecting.
Caution
Step 1 Click the Provisioning > Security > Data Comm tabs.
Modify the following fields, as necessary:
Step 2
•
•
•
•
•
Click Apply.
Step 3
If you changed the IP address, subnet mask, or default router, the node will reboot. This will take 5 to
10 minutes.
Step 4 Return to your originating procedure (NTP).
March 2005
This task modifies the ONS 15454 backplane IP address, subnet mask, and
default router. It also modifies settings that control backplane IP address
visibility in CTC and the ONS 15454 LCD. To perform this task, secure
mode must be enabled.
TCC2P cards must be installed.
NTP-A108 Back Up the Database, page 15-4
DLP-A60 Log into CTC, page 17-66
DLP-A433 Enable Node Security Mode, page 21-11
As needed
Onsite or remote
Superuser
IP Address
Subnet Mask
Default Router
LCD IP Setting—choose one of the following:
Allow Configuration—Displays the backplane IP address on the LCD and allows it to be
–
changed using the LCD buttons.
Display only—Displays the backplane IP address on the LCD but does not allow it to be
–
changed using the LCD buttons.
Suppress Display—Suppresses the display of the IP address on the LCD.
–
Suppress CTC IP Address—If checked, suppresses the IP address from display on the Data Comm
subtab, CTC node view information area, and other locations.
DLP-A435 Modify Backplane Port IP Settings
Cisco ONS 15454 Procedure Guide, R5.0
21-13