Dlp- A329 Create A Two-Fiber Blsr Manually - Cisco ONS 15454 Series Procedure Manual

DLP-A329 Create a Two-Fiber BLSR Manually
c.
d.
In the network graphic, double-click a BLSR span line. If the span line is DCC connected to other BLSR
Step 6
cards that constitute a complete ring, the lines turn blue. If the lines do not form a complete ring,
double-click span lines until a complete ring is formed. When the ring is DCC connected, go to
Click Finish. If the BLSR window appears with the BLSR you created, go to
Step 7
BLSR" or "Error While Creating BLSR" message appears:
a.
b.
c.
d.
Note
Verify the following:
Step 8
•
•
Note
Return to your originating procedure (NTP).
Step 9
DLP-A329 Create a Two-Fiber BLSR Manually
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > BLSR tabs.
Step 1
Cisco ONS 15454 Procedure Guide, R5.0
20-18
Depending on the problem, click Back to start over or click Cancel to cancel the operation.
Complete the "NTP-A40 Provision BLSR Nodes" procedure on page
completed accurately, then start this procedure again.
Click OK.
In the Create BLSR window, click Excluded Nodes. Review the information explaining why the
BLSR could not be created, then click OK.
Depending on the problem, click Back to start over or click Cancel to cancel the operation.
Complete the "NTP-A40 Provision BLSR Nodes" procedure on page
completed accurately, then start this procedure again.
Some or all of the following alarms might briefly appear during BLSR setup: E-W MISMATCH,
RING MISMATCH, APSCIMP, APSDFLTK, and BLSROSYNC.
On the network view graphic, a green span line appears between all BLSR nodes.
All E-W MISMATCH, RING MISMATCH, APSCIMP, DFLTK, and BLSROSYNC alarms are
cleared. See the Cisco ONS 15454 Troubleshooting Guide for alarm troubleshooting.
The numbers in parentheses after the node name are the BLSR node IDs assigned by CTC. Every
ONS 15454 in a BLSR is given a unique node ID, 0 through 31. To change it, complete the
"DLP-A326 Change a BLSR Node ID" task on page
This tasks creates a BLSR at each BLSR-provisioned node without using
the BLSR wizard.
None
NTP-A40 Provision BLSR Nodes, page 5-10
DLP-A60 Log into CTC, page 17-66
Required
Onsite or remote
Provisioning or higher
Chapter 20 DLPs A300 to A399
5-10, making sure all steps are
Step 8. If a "Cannot Create
5-10, making sure all steps are
20-16.
Step 7.
March 2005